OS 09381344 - Trying to perform Calc.MAFT

[ticker]

Also looking for some insight as to why I'm not getting any data for EFILive V2 AD1 when trying to log INNOVATE LM2 analog WBO2 output into the EFILive analog 5V inputs. Testing voltage with a volt meter at the orange connector coming into the bottom of the EFILive V2 shows 5 volts. Nothing shows up in the datalog under AD1 ?

[joecar]

Have you got all the calc pids from the Calc.MAFT tutorial selected in the scantool?

[joecar]

If you full flash OS 12212156 you will get the pid GM.VETABLE_DMA.

[joecar]

Disabling the MAF requires that the DTC is not ignored in table C6001/6002.

[joecar]

Do you have the LM2 ground connected to the ground pin on the orange connector?

[ticker]

Can you flash the original factory tune that goes with this engine/trans? Or you could flash in the stock 2002 F-car 12212156 factory tune.

I believe I have the original calibration with the 3 wire MAF settings. This is definitely worth a try for grins.

Have you got all the calc pids from the Calc.MAFT tutorial selected in the scantool?

I do not, there were several that were not available with the 09381344 OS

If you full flash OS 12212156 you will get the pid GM.VETABLE_DMA.

Thank you, I'll have to try and get my hands on this operating system.

Disabling the MAF requires that the DTC is not ignored in table C6001/6002.

Got it, thank you.

Do you have the LM2 ground connected to the ground pin on the orange connector?

I do have I do have Analog2 +/- (Brown/white and Dark Green) connected. Are you suggesting there should be a 3 ground wire ?