Ok, I've tried this on several other forums with little luck on top of an email to Innovate that went without response. Maybe someone here has hard-wired in their LC-1's? I'm trying to hook up my LC-1 in place of the stock narrow band sensor (B2S1) to avoid an additional bung installation. I'll be chopping the connector end off of an old O2 sensor to try and create a plug-n-play setup that can be easily used on different cars. Below is a wiring diagram from a 99 C5, which should have a similar setup to my f-body. Which wires do I connect where? I have a....

  • RED 12v supply
    BLUE Heater Ground
    WHITE System Ground
    YELLOW Analog out 1 (NBO2 voltage)
    BROWN Analog out 2 (WBO2 voltage)
    GREEN Analog Ground
    BLACK Calibration wire (for optional push-button/LED setup)




I'm guessing...

D (BRN 241) connects to the 12v supply
C (BLK 150) connects to the Heater Ground

...but I don't know where the rest go. :( It would be awesome if I could set this up so that the PCM doesn't throw any codes at me!!! Please help!!