Thanks, it makes a lot more sense to me now. Does this table have complete control of afr at wot?Originally Posted by black02ss
Thanks, it makes a lot more sense to me now. Does this table have complete control of afr at wot?Originally Posted by black02ss
'01 Silverado 1/8th 7.06 @ 96.5 1.55 60'
If the car is in PE mode, it is based on the factor and the MAF table I do believe.
Set the PE table to the AFR you want the engine to run at,then go to the B5001 table and move the table up or down till commanded=actual.
Bigger values runs richer and lower values run leaner. Work in small increments like 2% till you get it right.
This will work if your VE table is close if its far out then you will have to set that up.
\"You Can Never Have Enough Horsepower\"