Flashscan data logging..

[joecar]

green single box = 1 channel per pid
blue double box = 2 channels per pid

[joecar]

Click Device Settings (in the blue panel on the far left) and somewhere in there there's a setting to always include serial AFR pids.

im assuming its here? this is the way it was.

Yes, that's it...

Set Data Display to: AFR & EQ.

If you have two widebands, set Format to: Both widebands.

[waterbug1999]

ok.. i moved all the PIDS you listed and saved them. Do you know any other ones I might need? I am assuming that the LC1 AFR will be included since I changed the setting to AFR & EQ.

I also see the VSS is an KMH, how do I change it to MPH?

[joecar]

Serial AFR pids:

Goto Device Settings->Logging and checkmark external digital pids.

[joecar]

To show mph units, on VSS in the left pane do rightclick->Properties->Custom PID Properties->Quick Select->mph and click OK.

Remember to save and program.

[joecar]

You also want:
SPARKADV
KR

[waterbug1999]

You also want:
SPARKADV
KR

added that and switched them over to MPH and F*.. So, I guess I am good to go for some logging now.

I still need to go back in this thread and find the free air cal on my wideband 02 to make sure its good and I should be able to do it on the V2 now right?

I did notice that a few weeks ago when I was fooling around with it, I got the AFR from the LC1 to display and it was 1 point off of my dynotune AFR gauge. IS there a way to make them both read the same?

[waterbug1999]

Hey Joe.. I was trying to see what tune I had in the car but I cant read it, is say I am locked out. Whats this all about?

[waterbug1999]

and on the left, 2nd down, thats where my wideband 02 should display right? I have nothing.

[joecar]

Hey Joe.. I was trying to see what tune I had in the car but I cant read it, is say I am locked out. Whats this all about?

??? did you lock your tune...?

Post screenshots.