Activity Stream

joecar, I was not able to find CKREFCYL. This really needs to be a new post, and I can do that if you like. I am on to another issue, trying...

Dont think so cause my wideband innovate works fine. The only difference between innovate and plx is i need to use a 2.5mm to 3.5mm adapter on the...

Will not let me save pdf but here is screenshot

Anyone have S5361032SB for 2020 RAM ? Will pay for it

Sorry for the dumb question. But I'm in the middle of switching to an E85 only tune. If I change over to EQR on 93 oct then all my PE settings get...

Sorry I somehow missed this thread. Good you figured out precision :cheers:

Post the PLX user manual pdf here so I can take a look at it.

Could Tx and Rx be accidentally swapped?

Yes, it is written in Delphi and C. Regard Paul

You might not have a PID for intake valve temp in your ECM. If you're using V7.5, look at all your PIDs, make sure you can see all of them, not...

I have PLX SM-AFR with the bosch 4.9. For the life of me i cant get it to show in my V2 but my old LC1 shows up just fine. Any tips

I have a 2017 camaro ss. How do you log intake valve temp? I cant find a pid for that

Update, so I did confirm that the work-around did in fact work! would really be nice to simply be able to see that hidden idle rpm value/table in...

Thanks for the help! I'll go back to stock settings for B1832 and try adjusting from there again. I'll try logging ACCEP and THRA_A while cranking...

OK, so.... potential solution! Start with tune file "2010 GMPP E-ROD" (12638778) and update all values/tables with your tune file parameters "RevS...

Thank you

I have 32370731AH. I don't see AI but if I find it I'll throw it up

I don't have the euro file

I only use V7, so can't read your file ETCTP only shows */- 20 to 80 % ACCEP will show 0 to 100 % THRA_A will show real blade position B1832...

2017 Ram 2500 68RFE. I think I'm after 32370731AI?

Thanks izaks, I'll give the throttle area with idle contribution pid a try! As for B1832, I've basically maxed that out in the -40 to 90 degrees F...

Also, log Throttle area with idle contribution to see the actual TB open %

B1832 Cranking idle air