Activity Stream

Will a 5.3/4L80E work or do you need a 5.7 or 6.0 engine segment?

@Blacky, @GMPX ? Sent from my Pixel 5 using Tapatalk

That would be awesome, thanks!

I can send you a 0202005 COS5 with a 4l80 already segment swapped.

Guys, thanks for your help. You've taught me a great deal. Because of that there has been a little progress in removing detonation. I logged...

I have been on the Plex V3 pre-order list since March. Hopefully should arrive sometime soon. Really interested in testing it out. Are there those on...

On the RPI site is says this doesn't need to be rescaled , but its my understanding that you should see anywhere between 35-40 g/s at idle. So my...

Is this ECM compatible with your DBW pedal...?

Not all OS's have someof the pids. Also, make sure you did Info->Validate Pids from V7 scantool.

Here's the log that goes with it. Several shifts through the gears, generally 3-4 is at low load. Shift times are occasionally acceptable if I happen...

Needed to get some more logs and finally got that done. VSS is correct, all the other sensors are working properly in the trans (turbine speed,...

Dumb question but have you tried a new cable?

The fix for the CMF was to simply not send the clear DTC command prior to changing the VIN - it caused problems on the Cummins platform. Is it...

Looking for some help on a 2009 Trailblazer SS based calibration file in transplant street rod with no start condition. Cranks but doesn't fire the...

No it is not the same for a 2010

Most of the knock in these is not during power enrichment. it is mostly on part throttle. they do have a high cylinder pressure when the cam is fully...

No one?

Is APCYL_M the correct PID to log in order to determine where the engine is in terms of load, to make timing adjustments where I'm seeing knock? ...

It appears various "things" are going wrong. Does your VSS indicate the true speed (i.e. are tire size and axle ratio correctly accounted...

Thanks for posting. The V3 is expensive, but has many features including CAN bus connectivity, programmable knock threshold, and advanced...

The A/D inputs take 0-5V analog signals. Do you have a circuit that converts frequency to analog 0-5V...?

MikeM, Post your tune file and some logs. The VE multipler is applied as long as the input is applied, i.e. it is not a momentary input.