Activity Stream

cummins-bin do you also have cax for CMF 2450 ?

Hiya, Now that I think a bit. I have never had an issue with anything from Speartech, good call :)

Hiya, If it is easy enough for a short post, please reply or PM. I glanced at the e78 4 cyl turbo stuff vs the e78 v8 stuff and it appeared the X/Y...

I use only Spartech harness. They are hand made on a real engine/trans and then they run the engine with a laptop connected checking it. They use OEM...

Wow, I thought it was just me. I don't think PSI is alone though, it seems I have to repair almost any aftermarket harness I come across lately :( ...

not uncommon with psi harness

After a little more digging I found what I was looking for.

Right click on your Map, Map Properties, Cells, Empty if Less Than, then enter the value you'd like.

I have a ton ive built and they work mint.

"Added editing support for multiple CMF (CM2450B) 2022 operating systems. This one should not have been in the list of new features. We were working...

Hello. At first, congratulation for all your hard working team. I didn't undestand one thing. "Added editing support for multiple CMF (CM2450B)...

Here you go; https://www.mediafire.com/file/6ska6qeg7gjkjyt/2016_12664192_12669774_12660135_12660409_12660403_12660397_12672324_12672312.ctz/file

Wow Thank you so Much!1GC1KWE83GF244426

Will look into that. This is a factory LS1B pcm with original OS but FAST LSXr intake.

Might check to see if the wires (power and signal) to the MAP are backwards. Had that happen once on an aftermarket EFI system.

That's just it, the log shows 0 volts for every AFR WBO2 PID I could find. Which had me isolating the issue between the Innovate WBO2 and the...

Good to hear you got it running :cheers: Lesson learnt is to also visually inspect :)

Null midem cable may work... if it does not, then switch thevTx and Rx wires. I think RS232 needs 3vwires to function.

Please post your log file.

V7 calc pids format is Not for V8

You may have to do Info->Validate in the V7 scantool. calc_pid.txt is fot V7 only. V8 has a user interface that lets you define the calc pid...

UPDATE!! All is fixed no codes and headed to a dyno Friday. Problem was with a BRAND NEW PSI harness. The pins 39 and 71 for E38 J2 ecm connector...