Activity Stream

any that are supported yes.

I would like to unlink my autocal that I purchased from ATP trucks

thanks, so i can use e.g. wo2lam1 for any system/controller?

if you using the serial data input, then u just need to log "External Wide band Lambda" if analog, then u need to make up a pid to translate your...

Phased out with the V3

hi, im back to this. if i save a dashboard it appears in the vdash directory as you say. however i cannot open it, it sais "no results found". there...

Doesn't it default to #1? I confirmed this on a CM2100 the other day as it doesn't give you an option to set a tune when flashing a CSP.

It is set to 0 sec but it does not activate.

Replying from my phone, make sure the PE Delay timer is set to 0. I forget what the LQ9 had stock, but the LQ4 had a 60 second timer.

Hi ! I made a quick test today. My Lambda is around 1.00 or slightly above, even if push the pedal. I got KR. Is it something wrong with the PE....

Hi joecar, I read knock at low load (-8 degree/TP 20%) and it seem to run lean. Is it anything I can do to make it run somewhat richer. I am little...

Well I was gonna do it the way above. I even had a calibration cooked up, then had an epiphany: why not segment swap the system segment over and do a...

Haven't even tried, just curious if the update was eluding to something in the future.

Tbone, would like to hear if you were able to get into your E41 with your v2 flashscan? Problems\findings?

Thank you! This is the simple, straightforward statement I've been looking for in all the posts that mention it.

Thanks, guys. I've used the AutoVE to tune in the fuel map for the currently running calibration. Are you saying I missed something in the...

+1 see AutoVE tutorial.

Thanks Joecar. I will do the Calc.VET and also the idle tuning according to the guide. I will post the results.

B3647 = commanded fuel for COS B3605 = commanded fuel for original OS.

Hi Magnus, Do one pass of Calc.VET (running a MAF), and look at the results. You will still have to do idle tuning.