Activity Stream

Yes, it is written in Delphi and C. Regard Paul

You might not have a PID for intake valve temp in your ECM. If you're using V7.5, look at all your PIDs, make sure you can see all of them, not...

I have PLX SM-AFR with the bosch 4.9. For the life of me i cant get it to show in my V2 but my old LC1 shows up just fine. Any tips

I have a 2017 camaro ss. How do you log intake valve temp? I cant find a pid for that

Update, so I did confirm that the work-around did in fact work! would really be nice to simply be able to see that hidden idle rpm value/table in...

Thanks for the help! I'll go back to stock settings for B1832 and try adjusting from there again. I'll try logging ACCEP and THRA_A while cranking...

OK, so.... potential solution! Start with tune file "2010 GMPP E-ROD" (12638778) and update all values/tables with your tune file parameters "RevS...

Thank you

I have 32370731AH. I don't see AI but if I find it I'll throw it up

I don't have the euro file

I only use V7, so can't read your file ETCTP only shows */- 20 to 80 % ACCEP will show 0 to 100 % THRA_A will show real blade position B1832...

2017 Ram 2500 68RFE. I think I'm after 32370731AI?

Thanks izaks, I'll give the throttle area with idle contribution pid a try! As for B1832, I've basically maxed that out in the -40 to 90 degrees F...

Also, log Throttle area with idle contribution to see the actual TB open %

B1832 Cranking idle air

Attached is a good baseline to start at that fleece posts with thier conversion kits. ...

You're right, it was a seasoned Dyno tuner that said they like 13:1.

Your help is always appreciated. You and Statesman have both been a huge help to me.

Could you be a little more specific about how to control fuel and spark to control surging? I've tried putting all idle settings back to stock and...

Hello, Do you have stock file IA80047.00 (RAM 2500 2020) and 34320861AB (RAM 2500 2018)?

Hi, do you have the flash for S5361032SB ? This is a 2020 Cummins

Pulled about 45% out of the ve table also changed b0146. Still working on cold start atm runs like a hairy Bill Goat when you start it for 20 seconds...

What fixed it?

I'm looking thru your attached files, I don't know the answer yet.