Activity Stream

If I do this method with a vehicle with true dual exhaust. Do I need two different wbo2s ? And change the pid or would just using bank 1 be...

Congratulations on your baby! i hope you are better too. I'm a noobie here at EFI. I'm guessing that overlap is at .050 not .006 but even at that...

Yeah I assumed, thus my stupid reply

It was spam - the post and the user have deleted now. Regards Paul

Do you have an OS Number?

I understand what you are trying to do. Would be nice if the V2 or V3 could be used as a generic scan tool to log data, clear codes, check freeze...

Never any trouble opening the file Jim posted. Just when it loaded it gave that error and said ecm had no os

opened for me with no issues

You should be able to read the stock tune from your LBZ with your V3

Well, yes, that would 'work', but I'm looking for a way to leverage tools I have better, rather than spending more money each time I need to do a...

Sounds good. I didnt want to jump in there and drop the idle speeds a bit if it was going to mess up the whole tune.

Very useful.

If I am in V8 Scan Tool and F4: Charts and I right click on anything I get the following: Name: V8 scan screen shot 1.JPG Views: 1 ...

Its not terrible to do once you figure it out.. After getting use to V7.5 and switching over to V8 its kind of a shock. What kinda maps are you...

If you have the GM MDI The mopar Witech 2 Website says it supports J2539 Pass Throughs. I'm not sure what a single use subscription is. I know GM...

hmmm, that file was just taking your visible parameters and copying over to a previously used file I have on hand

Jim I tried that file and it errored and said checksum failed. I have worked on this for a bit now and it has stumped me.

Found this on Page 104 on the EFILiveV75Scan.pdf. You will need a 5 Volt source from the PCM to power your sensor.

Here you go sir.

Short answer... YES! Longer answer.... YES, the VE will always move around. You can get it better but it will never be what I would call good....

Would you happen to have calibration file for IA80027.04 for CM2450B?