Register
Help
Remember Me?
What's New?
Activity Stream
New Posts
New Events
Mark Forums Read
Forum
Advanced Search
Home
Activity Stream
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
Filter by:
Forums
Clear All
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
49 Minutes Ago
Blacky
replied to a thread
Selecting Cells
in
V8 Tune Editor
Why not just select all the cells you want to adjust and adjust them all at the same time? You can select non-rectangular areas using the Ctrl key,...
see more
4 replies | 10957 view(s)
4 Hours Ago
bondmatos
replied to a thread
Selling All of my Tested and Pre Built Files
in
General (Diesel)
Are you still selling all of this files?
see more
5 replies | 1418 view(s)
10 Hours Ago
oztracktuning
replied to a thread
Selecting Cells
in
V8 Tune Editor
is it possible to select maybe 5-10 cells in the VVE table and be able to adjust them then press the PGDn key and have the selected cells move...
see more
4 replies | 10957 view(s)
11 Hours Ago
andysc3
replied to a thread
New to me 2014 Chevy Cruze 1.4T, need advice on where to start
in
E78, E83, E84 PFI ECM's
yes, it's on my list to get. will have one by the end of the month. I picked up the zzp catless 02 pipe and mid pipe. But getting a p0598 code for...
see more
3 replies | 173 view(s)
19 Hours Ago
bondmatos
started a thread
Looking for stock file 19 aisin
in
Cummins 6.7L
hi, I'm looking for a stock file for a 19 3500 HO aisin with the recall cp3. thank you.
see more
0 replies | 26 view(s)
21 Hours Ago
joecar
replied to a thread
IAT Sensor Cal
in
Gen III V8 Specific
What are you trying to do?
see more
25 replies | 10546 view(s)
21 Hours Ago
joecar
replied to a thread
New to me 2014 Chevy Cruze 1.4T, need advice on where to start
in
E78, E83, E84 PFI ECM's
Install a wideband so you can log lambda to see what actual fueling is doing when not in closed loop.
see more
3 replies | 173 view(s)
22 Hours Ago
bondmatos
started a thread
Cm2450b
in
Diesel
hi, would anyone share a datalog from a 2019-2021 cummins? i would like to compare data with mine. thank you.
see more
0 replies | 26 view(s)
More Activity
No More Results
No Recent Activity