Activity Stream

Question about the commanded AFR's - I had to scale the injectors in my 2008 Avalanche e38 by roughly 20% (did it by multiplying IFR table by 0.8 and...

Yes, you can splice a new switch into an existing. Disconnect the batteries, the the wires from the current switch one at a time, then splice the...

No worries, no offence was taken.

I just read my reply from earlier and I came off like an *ss. Sorry about that.

Sorry for leaving that out. I appreciate your feedback, and understand why it is not possible. Thank you for all you guys do.

Well actually you didn't say anything about CSP in your original post :music_whistling_1: Anyway, this is not possible due to the lack of free...

Manual truck right now, but also be doing to my auto soon.

Manual or auto truck?

That makes sense. So on tunes that keep the egr functional, if I increase the size of my intake pipe I would need to adjust the values on one or both...

thank you I will look into that.

That is exactly what I was saying. Anyway to have them all inside the 4 CSP files?

I think what you're referring to is used to calculate the N/V load. The speedometer is controlled by the BCM module in the 13 and newer trucks. ...

The OP is referring to a CSP4 file. At least in the 13 and newer trucks, each CSP "tune" has Base, Mode 1 and Mode 2 with the rest of the modes...

Thanks JimP! Its OS 11551035

It's handled in the ECM, at least on the 2007.5-2012. It's in tire revs/km, 3 parameters, 2 parameters with the same value, 395.xxxx revs/km than...

What OS? I can make one.

Mass Charge Flow controls vane position within the boundaries of the min/max vane position tables and fresh air flow table is used to control the...

Actually depending on the OS you can tune Base + Modes 1 through to 13 in some cases, not sure what you mean by just having Base, 1 & 2.

Thank you sir.

V1 doesn't support CAN, only class 2, so it won't work on any newer vehicles. Sent from my HTC U11 using Tapatalk

Ill check the grounds and post back here.

I found the ecm pinout, The 'bench force' harness just uses 1 connector, C1 Black, There is B+, a few ign + but no grounds in there, Do they use the...

well don't I have egg on my face!!! the top of page 8.