Activity Stream

I realise that. I was just wondering if a similar strategy had could be used. I found a way to reduce the affect of torque reductions in the...

No, it is correct. EFILive is just following the cal files actual order of the segments. GM chose to change it for the Gen IV controllers vs what it...

Hey guys, I just haven't had time to do much with the amount of rain and general crappy weather we've been having. Here's what I have for now. I...

When upgrading an old computer is not possible, there are only a couple of options, build a completely new configuration or buy a ready-made system...

Are you using the latest release V8 software to read the ECM? It should just work (unless GM have blocked reading on that controller). If not, save...

I must have missed something then... I tried to read a 2018, but couldn't because of that... Is it no longer a pay thing, or something else? In that...

It is no longer necessary, it is all built in to the software now.

Thanks Paul... That gives be some hope lol. I don't have the car just yet, but when I do, I'll reach out. But what about the 'controller...

If you have an E81 and can read the tune file from the E81, please submit the file to EFILive via our service desk...

Can you please log this issue on our help desk: https://service.efilive.com/new-ticket Please include the appropriate log file(s), in this case the...

V2 or V3 If I recall correctly the V3 will accept Serial or CAN but no longer accepts analog signals ...

I bet if you post your tune file someone would be able to give some advice. Also Datalogging is your friend, compare MAF readout to MAF voltage and...

I'll double check and get back to you... I installed the latest of everything though... a totally new/fresh install of the v8 software, then I left...

Yes... the info posted by Highlander may be late, but it is a very good method to detect air leaks (you can localize the brake/maf cleaner using the...

+1.

Yes it was :cheers: the good old days :cheers:

What V8 software version do you have installed...? What FSV3 firmware version...?

To answer your original question, you can do the 4L80E trans segments (2 segments, the trans segment and the trans dtc/error segment) on top of your...

I'll take a look on Amazon.

Instead of TURBINE, look at TIS. Take note that TIS is read from the Forward Clutch housing which is driven by the Overdrive clutch, i.e. is inpit...

how do you mean? only the LB7 and LLY uses that torque strategy. the later models don't even have those tables.

8 Year old thread Bump?

Ha wasnt this the V2 release?

let me know if it works how you want.

Good Ol' Days.

Brake cleaner and looking at the o2 millivolts is the best way to find air leaks.