? Help with a a/d pid

[Wolfie]

I have a
AEM Digital Display Gauge
Fuel Pressure, 0-100 psi, Digital, Electric
It has a serial and a 0-5 volt analog output.
I would like to create a pid for the 0-5 volt analog output.
and, alas... don't know where to start.
Thanks....
Ed

[mr.prick]

What is the part number of the sensor?
You need to know what the voltage output to pressure is.
AEM lists 2 100psi sensors.
AEM PRESSURE SENSORS (http://www.aempower.com/images/products/Installation%20Instructions%20Pressure%20Sensor.pd f)

If it is 30-2130-100,
then it looks like it is the same as the one used here
LS1 Fuel Pressure Sending Unit Tutorial (http://download.efilive.com/Tutorials/PDF/LS1%20Fuel%20Pressure%20Sending%20Unit%20Tutorial. pdf)
In which the PID will be

*CLC-00-001
PSI 0.00 100.00 0.2 "({EXT.AD2}*25)-12.5"
#------------------------- ---- ------------ ---------------- ----------------
CALC.FP F001 CLC-00-001 PSI Fueling "Fuel Pressure"

[Wolfie]

30-2130-100
http://www.aempower.com/images/products/Installation%20Instructions%20Pressure%20Sensor.pd f
This is the one...

[Wolfie]

Oops... I replied before reading your entire reply...
Yes, that is it.
I should have looked there, but never gave it a thought.
Thanks!!!!!!!

[Wolfie]

Error report generated by EFILive at 13:51:13 on Feb 28, 2009
Error code: ERR_CONFIG/92
C:\Users\Ed Wolf\Documents\EFILive\V7.5\User Configuration\calc_pids.txt(49): Units PSI not found. .

uhhhhh.... didn't work.

[mr.prick]

Add this to the top.
*UNITS
#Code System Abbr Description
#-------- ---------- -------- -------------------------------------------------------------
PSI Imperial PSI "Pounds Per Square Inch"

Or use this
4797

[Wolfie]

OK THANKS!, that worked...
on another note.
I had another calculated pid on that page, which I just removed.
To put it back, would I just change
F001 CLC-00-001
to
F002 CLC-00-002 on the other one???

[mr.prick]

That`s what I do.
The FP was my first one and I am up to 23 now.

[Wolfie]

--never mind, I got it.
Just had to do a bit more searching...
I had the format wrong.
Thanks again!