PDA

View Full Version : Logging for adjusting B1010



Cougar281
March 8th, 2009, 01:07 AM
What do I have to log in order to get the scan tool linking to work right in B1010? I'm logging the following:

RPM
FRPCOMM
FRPCOM
FRPADES
FRPACOM
FUELQ_THR_M
FUELQ_MAIN_M
FRPDES
FRPACT
MAINRATE
PILOTRATE

Based on the table's vertical axis, it appears as if the FUELQ_MAIN_M PID should link up with the table, but the highest it goes in my log file is 95mm3. the grey box stays at zero, so I have no idea where I need to change in the table. I've gotten an idea or two that I'll try tomorrow, but if I need to change something higher up than the first few tables, I'd like to be able to tell where in the table it needs to be changed.

lakingslayer
March 9th, 2009, 04:40 AM
I've come to the conclusion that not all the Tuning tables are linked to the scan tool.

GMPX
March 9th, 2009, 09:42 AM
GM.FUELQ_MAIN_DMA is not right for that table. It should be a desired fuel flow value, not the injected fuel quantity. I'm not sure if the ECM supports a fuel flow PID in those units, if it does not then it will have to go on the low priorty to add DMA PID list.

Cheers,
Ross