Logging for adjusting B1010

[Cougar281]

What do I have to log in order to get the scan tool linking to work right in B1010? I'm logging the following:

RPM
FRPCOMM
FRPCOM
FRPADES
FRPACOM
FUELQ_THR_M
FUELQ_MAIN_M
FRPDES
FRPACT
MAINRATE
PILOTRATE

Based on the table's vertical axis, it appears as if the FUELQ_MAIN_M PID should link up with the table, but the highest it goes in my log file is 95mm3. the grey box stays at zero, so I have no idea where I need to change in the table. I've gotten an idea or two that I'll try tomorrow, but if I need to change something higher up than the first few tables, I'd like to be able to tell where in the table it needs to be changed.

[lakingslayer]

I've come to the conclusion that not all the Tuning tables are linked to the scan tool.

[GMPX]

GM.FUELQ_MAIN_DMA is not right for that table. It should be a desired fuel flow value, not the injected fuel quantity. I'm not sure if the ECM supports a fuel flow PID in those units, if it does not then it will have to go on the low priorty to add DMA PID list.

Cheers,
Ross