This is probably something dumb... Auto VE

[zapp168]

I am just too pooped to poke around right now. Went to run Auto VE and it seems to be working but as I am driving I notice a pattern emerging on the AFR table .....ALL green on the left going to light green, yellow and finally red as the RPMS climb in almost perfect rows, it is not corrosponding to my gauge reading at all. I have used the same set up forever. I must have clicked something somewhere????? Any ideas where to start? Set up is in sig
Thanks

[zapp168]

Well as I looked around, I found a bad connection where the gauge wire meets the flash cable, have not tried it yet, but it was weird that I was getting all .99 on the low then a perfect row of 1.1 then 1.3 and so on...i wonder where those numbers came from? Like I said it was dumb

[5.7ute]

That is a very common thing to happen when the wideband input is not working. The BEN pid will report different values as the commanded AFR changes since the reported AFR doesnt change.