PDA

View Full Version : Logging E38 Analog PLX AFR



Tre-Cool
March 24th, 2009, 10:27 PM
Can someone take a look my config from my options.ini file and tell me where i have gone wrong with trying to log AFR from my plx via the AD1 port.

I can see voltage but no AFR.

ECM, KNKRET, 0:2:1:10:10
ECM, IAT
ECM, ECT
ECM, SPARKADV
ECM, AFRATIO_M
ECM, TRQTRANS
ECM, APCYL_M
ECM, OCTSCL_M
ECM, MAP
ECM, BARO
ECM, RPM
ECM, ETCTP
ECM, VSS
-, AD1, AFR_WB1, V, AFR, 3, 2.000000, 10.0000000, N
-, calc.ben_plx_E38
-, calc.afr_plx1.afr
; T42 4/5 speed
TCM, TFT, 0:100:2:30:30
TCM, TIS
TCM, TOS
TCM, TCCSLIP
TCM, SHIFTLAST
TCM, GEAR

joecar
March 25th, 2009, 01:55 AM
Can someone take a look my config from my options.ini file and tell me where i have gone wrong with trying to log AFR from my plx via the AD1 port.

I can see voltage but no AFR.

ECM, KNKRET, 0:2:1:10:10
ECM, IAT
ECM, ECT
ECM, SPARKADV
ECM, AFRATIO_M
ECM, TRQTRANS
ECM, APCYL_M
ECM, OCTSCL_M
ECM, MAP
ECM, BARO
ECM, RPM
ECM, ETCTP
ECM, VSS
-, AD1, AFR_WB1, V, AFR, 3, 2.000000, 10.0000000, N
-, calc.ben_plx_E38
-, calc.afr_plx1.afr
; T42 4/5 speed
TCM, TFT, 0:100:2:30:30
TCM, TIS
TCM, TOS
TCM, TCCSLIP
TCM, SHIFTLAST
TCM, GEAR
Hi TC,

Your conversion needs to go at the end in the PCU section... (and while logging you press ENTER and AD1 changes to AFR).

You can't call out calc pids in Options.txt/Options.ini... you add these in later when viewing the log from the scantool.

see my Options.txt attached.

Options.ini is used with earlier versions of firmware; Options.txt is used with the later versions;

What version of bootblock/firmware do you have...?

Tre-Cool
March 25th, 2009, 03:19 AM
im running the latest bootblock and firmware for bb logging.

i should have said options.txt, but i didnt even notice it had changed from an ini file. :-)