Fuel Pressure-Calculated PID

[Lextech]

I am going to log fuel pressure and have read the tutorial. I have a V7 and V7.5 folder in my UserConfigurations. I installed the F/P calculated PID to both of them. The tutorial says to Open the Scan Tool and open the PID tab and select GM-EGR and in the Calculated PID dropdown select Calc-FP. I can't seem to see the Calc-FP PID. What am I doing wrong????

Jeff

[mr.prick]

If you wrote the PID like the tutorial,
look under the Fuel section of the PIDs too, see if it is there.

After editing the calc.pids.txt you will need to reboot the scan.exe to see any changes.

[Lextech]

I was messing with it last night before bed. I did not know about the reboot. I will check it when I get home from work.
Thank You,
Jeff

[Lextech]

Well, I just checked again---Can't find it. The calculated Fuel Pressure PID is loaded EXACTLY as the tutorial says. I have checked the Calculated and Fuel dropdowns--Supported and Not Supported--Still can't find it.

Jeff

[mr.prick]

Try this just to be sure.
5011

[Lextech]

Well, I don't know what made yours work---But it did. It looked just like the PID I had---But apparently it wasn't.

Thank You.

Jeff

[bmax]

Hello,

Quick question.
Do you copy and paste the pid info into an existing file somewhere or do you make its own file and drag/drop it into the v2 with EE? :confused:

Thank you

Brad

[mr.prick]

You can copy the PID in post #5 to your existing calc.pids.txt or
save as: calc.pids.txt
in C:\My Documents\EFILive\V7.5\User Configuration
overwriting your existing one

[bmax]

Thank you.




.

[mr.prick]

:good: