View Full Version : Replacing MAF
SSpdDmon
September 21st, 2005, 12:04 AM
http://www.powerflowracing.com/prdlist.asp?PG=2&PSG=32
It looks like a "ricer" site. But if you're looking to remove the MAF, there's some 3" tubing and couplers about 2/3's down the page that could make it easier/cleaner looking than a trip to Home Depot.
BowlingSS
September 24th, 2005, 11:17 AM
I am looking for something that looks good. I will check out the site.
Thanks,
Bill
mistermike
September 24th, 2005, 02:09 PM
www.airflo.com
joecar
September 24th, 2005, 08:32 PM
www.airflo.com
He he he, Now that's a piece of pipe...!!! :D
BowlingSS
September 25th, 2005, 02:16 AM
http://www.powerflowracing.com/prdlist.asp?PG=2&PSG=32
It looks like a "ricer" site. But if you're looking to remove the MAF, there's some 3" tubing and couplers about 2/3's down the page that could make it easier/cleaner looking than a trip to Home Depot.
Now I just need to figure what I need. I need to make some measurements.
Thanks,
Bill
BowlingSS
September 25th, 2005, 11:55 PM
Most of the sizes are 3" which is too small.
Bill
SSpdDmon
September 26th, 2005, 04:09 AM
Most of the sizes are 3" which is too small.
Bill
Too small? Stock MAF is 75mm right? That translates to 2.95 inches. How is that too small?
BowlingSS
September 26th, 2005, 06:33 AM
Most of the sizes are 3" which is too small.
Bill
Too small? Stock MAF is 75mm right? That translates to 2.95 inches. How is that too small?
I measured the outside of my TB and it is 3.96". I measured the SLP bellows and it is 3.9" inside dia.
Bill
SSpdDmon
September 26th, 2005, 11:48 AM
Most of the sizes are 3" which is too small.
Bill
Too small? Stock MAF is 75mm right? That translates to 2.95 inches. How is that too small?
I measured the outside of my TB and it is 3.96". I measured the SLP bellows and it is 3.9" inside dia.
Bill
oh
TAQuickness
September 27th, 2005, 04:17 AM
3" is suffecient. I used an old SLP slash tip for mine. 15* angle on one side, 10* on the other side, and 2 3" rubber couplers from Home Depot.
http://www.ls1tech.com/forums/showthread.php?t=359184
I replaced a stock screened OEM 85mm with this pipe. Leaned me out 1-2% across the board ;)
joecar
September 27th, 2005, 06:14 AM
That's unusual but very cool, using an exhaust tip for a MAF replacement.
:two thumbs up:
...And it says "SLP" on it...
8) 8) 8)
TAQuickness
September 27th, 2005, 07:39 AM
...And it says "SLP" on it...
8) 8) 8)
;) I should sell it back to them as the !MAF mod ;)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.