View Full Version : Need help
Haans249
April 15th, 2009, 07:52 AM
Hello All,
So, i'm about to start my new motor up, BUT, i cannot tune my vehicle, because my serial number on the PCM went to 00000000 for some reason. So, it locked up my other license. I did a FULL reflash to get a new serial number in the PCM (like the software suggested) and now I CANNOT tune my car. I have no other licenses because one is used up with 000000000! PLEASE ADVISE
Thanks,
Adrian
joecar
April 15th, 2009, 08:19 AM
Adrian, I notified Tech Support.
Which build version are you using (Help->About)...?
Before proceeding can you update to build 83 from the downloads page at www.efilive.com.
Do you have FlashScan V1 or V2...?
Blacky
April 15th, 2009, 08:26 AM
Hi Adrian,
Please send your FlashScan serial number and authentication code as per these instructions: http://www.efilive.com/index.php?option=com_content&view=article&id=110&Itemid=120
Also send in the *.blx file that is created when you try to flash your controller as per these instructions: http://www.efilive.com/index.php?option=com_content&view=article&id=111&Itemid=121
Send the details to paul@efilive.com and I'll organize a replacement license for you.
Regards
Paul
Haans249
April 15th, 2009, 09:04 AM
I am using the latest build, emailing Blacky now...
Haans249
April 15th, 2009, 09:15 AM
Well, i was using the latest build a while ago, and it locked the last one, updated recently while my motor was down. Just started up the motor and it sounds niiiiiiice, just can't tune yet! :(
joecar
April 15th, 2009, 10:50 AM
Make sure you use the latest build.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.