View Full Version : LC-1 doesn't work pass though
samh_08
April 18th, 2009, 12:41 PM
Hey all, I manged to get my LC-1 to work BBL but I am not having any luck getting it to work with pass through. Is there something I am looking over or whats the deal? I have everything updated to the latest..
Please let me know ASAP. Thanks guys :cheers:
mr.prick
April 18th, 2009, 01:34 PM
Do you have all the PIDs selected for it?
samh_08
April 18th, 2009, 01:40 PM
Yes I believe so. Refresh my memory though ;).
Will the 2nd LED still flash on the V2 unit if all is working?
I would like confirmation on how to hook up my serial cables. My sLC1 cable from TAQuickness is hooked into the 'out' on the LC1. Do I put the terminator plug in the 'in' side or what does that go to?
Thanks for the help,
Sam
mr.prick
April 18th, 2009, 02:38 PM
Terminator plug must be installed in the terminal marked IN.
samh_08
April 19th, 2009, 03:54 AM
Well that worked! Thanks for the help Mr. Prick.
I think Im all set. Is there any other settings I need to program to the LC-1 to make sure its accurate?
joecar
April 19th, 2009, 08:53 AM
No that's it, just make sure you have done a free air calibration.
You can sanity check it by going into CL or SOL, the wb AFR should show stoich.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.