View Full Version : 8100 Vortech Tuning
MN C5
September 23rd, 2005, 10:55 PM
Will Flashscan work on a 8100 motor? its and 03. I know it logs fine but was wondering if anyone had programed a pcm with a 8100 motor
wait4me
September 23rd, 2005, 11:33 PM
Yes it works. Ill send you some files when you are ready. I need to track down one table that makes the throttle hang... :) The tune is really nice, but the sticking throttle has me baffeled..... :(
N0DIH
March 21st, 2008, 06:02 AM
Throttle hang? Did you find out what caused it? I take it this one is a ETC engine?
The reason I ask, is I am getting one to tune here in a few weeks. Not a modified engine, stock, just will get a CAI most likely.
Yes it works. Ill send you some files when you are ready. I need to track down one table that makes the throttle hang... :) The tune is really nice, but the sticking throttle has me baffeled..... :(
arubenstein
December 7th, 2008, 05:15 AM
Yes it works. Ill send you some files when you are ready. I need to track down one table that makes the throttle hang... :) The tune is really nice, but the sticking throttle has me baffeled..... :(
Any update as to what this was?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.