kwhiteside
June 9th, 2009, 11:25 PM
I'm trying to take in what I can from your threads and found a thread about reading HP and TQ from your runs so you don't need a dyno to tell you that. Hmmm, sounds great.
So I copied the other guys z06 data from his calc_pids.txt into mine and reloaded my .efi scan. All the calcs happen on standard readings so the data should already be there ( I think, but I'm very new :) ).
Notice from the attachments that 3 of 6 pids show up as selectable, one of 6 show up in the data tab. In the dashboard, I get a solid zero for the pid that was there (also get zero for the standard POWER_RW pid that comes standard.
Please educate me
Why no readings in dashboard?
Why only 1 of 6 in data tab?
Why only 3 of 6 in pid tab?
All 6 use the same data to calc on so I'm guessing I have formatted something incorrectly in my calc_pids.txt file.
So I copied the other guys z06 data from his calc_pids.txt into mine and reloaded my .efi scan. All the calcs happen on standard readings so the data should already be there ( I think, but I'm very new :) ).
Notice from the attachments that 3 of 6 pids show up as selectable, one of 6 show up in the data tab. In the dashboard, I get a solid zero for the pid that was there (also get zero for the standard POWER_RW pid that comes standard.
Please educate me
Why no readings in dashboard?
Why only 1 of 6 in data tab?
Why only 3 of 6 in pid tab?
All 6 use the same data to calc on so I'm guessing I have formatted something incorrectly in my calc_pids.txt file.