Someone have a Custom Options File?

[turboolds]

anyone have an options file for the newest firmware, in imperial units that i can load onto FS.

[joecar]

Which version of FS firmware do you have...?

[turboolds]

the newest one, the one from june 9 2.06.12 and the correct boot block

[Brian1]

Just what is in the options.txt file as default is what you want as Imperial?
Or are you logging other PIDs?
With the ScanAndTune app from V8 you can read the options.txt file from the Flashscan II and then go and change the PIDs for each PID for that PID set to Imperial. Then program them back to the Flashscan II.

Brian

[joecar]

the newest one, the one from june 9 2.06.12 and the correct boot blockOk, here is my Options.txt (see attached)...

copy it to the right place which should be:
C:\Documents and Settings\All Users\Application Data\EFILive\V8\Config

Use the pidlist named "LS1B" "eng/tran".

What car do you have...?

[joecar]

Just what is in the options.txt file as default is what you want as Imperial?
Or are you logging other PIDs?
With the ScanAndTune app from V8 you can read the options.txt file from the Flashscan II and then go and change the PIDs for each PID for that PID set to Imperial. Then program them back to the Flashscan II.

Brian+1

Exactly what Brian said.

Have you seen this before:

http://forum.efilive.com/attachment.php?attachmentid=5550&d=1244477039

[turboolds]

i have an o1 zo6, i like the way the old version had all the different pcm, and you could switch to imperial easier

[joecar]

In the blue section (upper left) you can select the controller and name the pidlist (rightclick->Properties).

In the green section (lower left) you can set a pid's custom units (rightclick->Properties) as shown above (for VSS the "Quick Select" dropdown shows mph, the numerical constants appeared when mph was selected).

You do need V8.1 installed to be able to do that.