V2 DSP switching

[musclecar400]

I just recieved my V2 and I'm trying to set it up to switch my DSP tunes. I was following the tutorial pdf and wass having no issues until I pluged my V2 into the truck and tried to select the PID that I loaded on the V2 using EFIlive explorer. There are only the 4 sample vehicles. If I go to Tuning and then to the switch tune feature it says that this feature is not available yet.

Any ideas on what I am doing wrong?


I downloaded the v8.1.2 build 58 and 7.5.5 build 88. I have also upgraded the V2 firmware to 2.06.12 with Bootblock 2.06.02.

Thanks
Jacob

[wilsonck]

you probably did not copy options.txt from the folder at the top of efilive explorer to the bottom window, so it didn't copy it to the V2.

[joecar]

Open EFILive Explorer, position the bottom pane on the [Config] tab, and post a screenshot of this.