Highlander
August 11th, 2009, 06:23 PM
Base spark table is not being used...
I have 2 Z06s and I found this a bit weird. If I command 28º on the base idle spark table and 21º on the HO table, the PCM will not go to the idle table and it will not do over/underspeed timing to adjust the idle...
How come?
I thought this was a throttle based parameter and/or speed like in the lS1s. There is no parameter for it though.
I have 2 Z06s and I found this a bit weird. If I command 28º on the base idle spark table and 21º on the HO table, the PCM will not go to the idle table and it will not do over/underspeed timing to adjust the idle...
How come?
I thought this was a throttle based parameter and/or speed like in the lS1s. There is no parameter for it though.