Coil Brackets - Small Block Chevy and LT1

[S10Wildside]

Production coil brackets are now available. These brackets should fit just about any center bolt SBC valve cover and provide adequate clearance for most PCV, breather, and oil fill. Outer coils are positioned to clear most A/C boxes, brake boosters, and front accessories. Aluminum CNC production. Brushed appearance.

Who: EFI Connection
What: Gen 1 SBC and Gen 2 LT1/LT4 Engines. Basically any SBC with center bolt valve covers.
Where: http://www.eficonnection.com/24x
When: September 2009
How Much: $550.00 fully dressed (set of 2 brackets, fasteners, 8 LS2 coils, and coil pack harnesses). $500.00 if purchased with a 24x package.

http://www.eficonnection.com/24x/images/CoilBracketsFullyDressed.jpg

http://www.eficonnection.com/coilpercylinder/EFI_24x_Production_Coil_Bracket_01.jpg

They also fit the LT1 engine (notice alternator clearance).

http://www.eficonnection.com/coilpercylinder/EFI_24x_Production_Coil_Bracket_03.jpg

[LSRacing]

This is a beautiful setup. A must have for LT1 guys. Too bad I already installed the LS2 into my car. I kind of regret it now that the 24x system is out. Would have been much easier to use your system. Keep up the good work.

[S10Wildside]

Here's the first installation of these coil bracket assemblies.

http://www.eficonnection.com/24x/images/24x1989GTA03.jpg

http://www.eficonnection.com/24x/images/24x1989GTA04.jpg