PDA

View Full Version : PLX>Flashscan V2 install



-=Mod=-
August 22nd, 2009, 07:17 AM
I've looked everywhere on how to install a PLX SM-AFR to V2 but cannot find anything as far as wiring goes.
I've tried to register at PLX forums and each time I get php error codes.

What wires go from where to where from the PLX to the V2?

Thanks for any and all help.

This does not help
http://forum.efilive.com/showthread.php?t=81

mr.prick
August 22nd, 2009, 07:45 AM
I wouldn't think that thread would help,
it's about 2 years older than the V2. :hihi:

If you want serial WBO2 connection you will need to do some hacking
PLX SM-AFR Serial upgrade (http://forum.efilive.com/showthread.php?t=7726&highlight=plx+serial)

-=Mod=-
August 22nd, 2009, 08:30 AM
Not a big fan of soldering into a part I just paid $200 for.
There are so many people out there using PLX. There has to be an easy way to hook this thing up.

joecar
August 22nd, 2009, 08:33 AM
If you want serial AFR (recommended), then follow Mr.Prick's link.

Otherwise if you want analog AFR, connect the PLX's analog signal output to FlashScan's AD1+ input and the PLX's signal ground to FlashScan's AD1- input.

-=Mod=-
August 22nd, 2009, 10:12 AM
I'm a visual person. :hihi:
Would this be correct doing an analog setup?

joecar
August 22nd, 2009, 01:18 PM
Yes that is correct (the red and black ones).

-=Mod=-
August 22nd, 2009, 01:22 PM
Thank you