PDA

View Full Version : FUELQ_MAIN_DMA doesn't show up



THEFERMANATOR
September 20th, 2009, 12:17 PM
When I log with the V2 by itself I select the FUELQ_MAIN_DMA Main Injection Fuel Flow Rate 2 PID and it shows up on the V2 while logging, but when I upload them to the PC to play them back it doesn't show up on the PC. All of my others seem to come through except this one. Am I doing something wrong? The vehicle is my 95 SUBURBAN with an 01 DURAMAX/ALLISON in it.

Blacky
September 20th, 2009, 02:01 PM
You're not doing anything wrong.

There is a bug in the DMA PID handling between BBL and the Scan Tool software. If has been fixed in the next update. Which is due out within the next few days.

Regards
Paul

THEFERMANATOR
September 20th, 2009, 03:37 PM
I just wanted to make sure it wasn't me. I'm new to EFILIVE and still trying to learn it all.

gmh308
September 21st, 2009, 12:53 AM
You're not doing anything wrong.

There is a bug in the DMA PID handling between BBL and the Scan Tool software. If has been fixed in the next update. Which is due out within the next few days.

Regards
Paul

Thanks Paul. Good to see these fixes making it in. :)