PDA

View Full Version : can not connect



Jetmech
September 28th, 2009, 12:22 PM
I just got my EFI today and I am trying to download my ECM data. everytime I try and connect to the ECM it is telling me EFI live cannot connect to flashscan. Any ideas?

joecar
September 28th, 2009, 12:34 PM
Hi Jetmech, welcome to the forum...:cheers:

It says that when you press the green connect button from the scantool...?

Did you go File->Select Controller and select your ECM...?

Jetmech
September 28th, 2009, 12:37 PM
yes that is correct. as soon as I click start it says efi cannot connect to flashscan. Is it a computer setting maybe?

Trippin
September 28th, 2009, 01:00 PM
Sounds like a driver issue.

Verify that the USB driver is loaded correctly.

If using XP, right click on "My Computer" >select "Properties">Hardware>Device Manager.

With your EFILive device plugged into your USB port, verify that Flashscan is listed under USB devices.

Jetmech
September 28th, 2009, 01:05 PM
ok and which driver do i want? amd64 or i386

GMPX
September 28th, 2009, 01:07 PM
Depends on your CPU in the PC. i386 would be the most common.

Jetmech
September 28th, 2009, 01:23 PM
Perfect got it. Thanks for your help. GREAT support. Drivers were screwed up.

Trippin
September 28th, 2009, 01:55 PM
;) Glad it worked out.

Dewglass
November 29th, 2010, 05:21 AM
I am having a similar problem with the V2 not connecting to the laptop. (for scan tool) for a 2002 truck (4.3) using 411 PCM

The OBD port on the truck shows 12v and a signal from the class 2 data.

Connecting just the V2 to the OBDII port lets me dtc'S etc, but the connection cannot be read in the laptop.

Going into the device manager (Windows XP SP3) the USB port recognizes the V2 connection and states that it is working properly. (??)

So where else could I poke aroung to make this connection work? I have selected the correct PCM for scanning and the software was recently downloaded succesfully from this site.

What else could I try? :shock:

Is there a robust FAQ/help page with common connection issues you can point me too? (did several searches)

Chevy366
November 29th, 2010, 05:59 AM
Look at the bottom of each post section , there is a "similar threads" there that might hold the answer .
Make sure you have latest software/firmware .
Silly question , but you did click the connect button correct ?
If you select the "Console" tab you can see the process after you click the connect button (round green button at top) .

Tordne
November 29th, 2010, 07:31 AM
Check you have the latest software and firmware installed. See these guides for more info:
- Software Updates (http://support.efilive.com/kb_article.php?ref=5404-IJZV-0820)
- Firmware Updates (http://support.efilive.com/kb_article.php?ref=7243-SFGL-2949)

As of this post the latest versions (GA releases) are:
- 7.5.6 Build 133
- 8.1.2 Build 115
- 2.06.41 FlashScan V2 firmware.

Also, set your cable selection properties in the Scan Tool as per this image:
http://forum.efilive.com/attachment.php?attachmentid=9296&d=1287888148