LTFT Tuning?

[stevedarman]

I have read the procedure on tuning with LTFT using CLSD setup
Can any one advise me how to do this with using MAF turned on.

[joecar]

To do this in CLMAF, follow the same procedure but with MAF enabled and B0120 set to some number below 400 rpm... you will be adjusting B5001 so you need to log MAFFREQ and MAF (same as shown on the axes of this table).

[Johno]

Does this mean i go through clsd to get ve table.
Then clmaf to get maf table dialed in.
Simular to auto ve then automaf?

[joecar]

No, where it says VE/B0101 replace with MAF/B5001...

Create a map for B5001 (copy-with-labels from B5001 and then paste-labels into the map)...

Then set B0120 to 400 or less...

Then log data, view BEN map, apply filtering, paste-multiply into B5001.

[stevedarman]

sorry if i sound slow hear but,
does this mean i dont touch the ve table at all?
just the maf table

[mr.prick]

Yes,
one then the other.

[joecar]

You either edit the VE table or the MAF table... don't edit both tables together... the reason is that one or the other table is disabled.