BRD-PREY
October 13th, 2009, 12:03 PM
I mounted the sensor in the flowmaster merge, and ran the wire up under the passenger seat. this allowed me to keep the electronic unit in the car and reduce its exposure to the elements.
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02276.jpg
I used this grommet from Mr Gasket for valve covers as it has to fit over the sensor.
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02274.jpg
The sensor comes up right where all the electrtic seat wires come up through the carpet. so I make a small cut in the front right for the wires to go back down and they follow the floor along the outside near the kick panel and come up on the right side behind the kick panel.
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02275.jpg
I ran the gound for the blue/white wire to the back of the head and the cal ground to a stud under near the battery. I bought this fuse panel
so I could control power, gnd and accessory power. I hate trying to find good power and grounds when I wire stuff. I lucked out as it all fit on the back side of the glove box, this made for a clean install.
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02278.jpg
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02279.jpg
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02276.jpg
I used this grommet from Mr Gasket for valve covers as it has to fit over the sensor.
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02274.jpg
The sensor comes up right where all the electrtic seat wires come up through the carpet. so I make a small cut in the front right for the wires to go back down and they follow the floor along the outside near the kick panel and come up on the right side behind the kick panel.
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02275.jpg
I ran the gound for the blue/white wire to the back of the head and the cal ground to a stud under near the battery. I bought this fuse panel
so I could control power, gnd and accessory power. I hate trying to find good power and grounds when I wire stuff. I lucked out as it all fit on the back side of the glove box, this made for a clean install.
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02278.jpg
http://i689.photobucket.com/albums/vv257/BRD-PREY/DSC02279.jpg