FlashScan issues

[GrimReaper]

As i was updating i apparently did the firmware before the bootloader, and now i can't do the bootloader. my flashscan v2 just sits at the screen that reads EFILive FlashScan V2 and the center light is on. What actions do i need to take to correct my screw up

[Brian1]

Sounds like dead poll. Check the link in post #5 on upgrading and see if it helps.
http://forum.efilive.com/showthread.php?t=10920&highlight=dead+poll

If not search ' dead poll ' and see if that is what is going on. All I know to do till maybe someone says what to do.

Brian

[GrimReaper]

those are the instructions i screwed up...lol. the only way i can get it to connect is in dead poll mode. But actually i just needed to load old firmware again....then i could update the bootloader and finally the new firmware. Thanks for your help!

[Ira]

These are supposed to be the same but they might not be, one of them should let you recover from this.

www.fishtuning.com/Downloads/BootRecover.zip

www.fishtuning.com/Downloads/EFILiveRecovery.zip

Ira

[joecar]

GR, did you get it going...?