AutoVE, No MAP reading

[W_D_R]

Was attempting my first AutoVE last week and noticed that I only had hits in my BEN map under the 15 column.

Under PIDs I have intake manifold absolute pressure selected, units are psi kpa and imperial.

The dashboard gauge read manifold pressure and is crossed out.

Not sure where the problem lies, I think its just an adjustment somewhere that I have out of whack.

Wes

[joecar]

Hi Wes,


In scantool:
- on PIDs tab, select the SAE.MAP pid and do rightclick->Metric;
- on Data tab, verify SAE.MAP has units kPa.

In tunetool:
- goto B0101 and look at the MAP axis...
- does it say kPa...? if yes, then you're good, else do this:
-- go Edit->Configure Display Units,
-- select B0101 and do rightclick->Metric,
-- click OK,
-- exit and restart the tunetool.

If dash page shows manifold pressure crossed out then that pid is not selected...
be aware that there are two pids called MAP: SAE.MAP and GM.MAP...
you want chart/gauge to use the SAE.MAP.