COS 5 Fuel VE multiplier

[Highlander]

For Nitrous applications, does it work while in closed loop???

I believe you can't do MAF operation on it, or does it multiply MAF too?
Thanks

[joecar]

You mean A0015...

My understanding is that it only depends on the state of the switch wired to the spare pin, regardless of OL/CL...

I don't know about MAF...

I'll ask Ross.

[Highlander]

That i know! What i wish to know is that the multiplier works even for closed loop!

[5.7ute]

Sounds like you are looking at making an ethanol switch. It would be easy enough to test, just ground the pin with the tables populated & watch your fuel trims.

[GMPX]

It multiplies the VE table numbers, so it should work in closed loop too, SD.

Cheers,
Ross

[MikeM]

I was just searching for an answer to this same question. I'm in closed loop, and it looks like no matter what I set my VE multiplier to, it only works for a split second before it reverts to my normal PE mode. I have a log where I had pin 56 grounded, rich spike, and then pin 56 open and normal PE transition. Is there a trick I haven't found yet to get this working in closed loop?

[joecar]

MikeM,

Post your tune file and some logs.

The VE multipler is applied as long as the input is applied, i.e. it is not a momentary input.

[Highlander]

Post log and tune. This has always worked great. It is ve mode only. it does work in closed loop no problem no matter if its in PE or not.

[joecar]

+1 post files.