Jan 17 RC2 Problems

[ScarabEpic22]

When opening a .tun file in V7.5.6 build 103 it does not default to the main calibration tab like normal. Instead I get a blank white screen. Everything works great once I select a tab, just the initial open on any file causes this issue. Doesnt matter if a file's already open, opening another one has the same blank screen.

Ill report any other issues here if I find any.:fluffy:

I would have posted it in the main thread, but I dont have the appropriate permissions to do so.

[joecar]

+1... I see same blank screen on file open and startup.

[Blacky]

http://forum.efilive.com/showthread.php?p=113104#post113104

[jfpilla]

Paul,
Also!
On the scan tool:It dropped my default dash. I recovered that. It removed the check mark.
Joe

[Chevy366]

No hang , "reboot" did not hang at firmware update this time . No "success" dialog , but no hang either .

Just in case anyone was curious .

[ScarabEpic22]

Ok, 103A fixed the blank screen error but Ive found that clicking either the Read or Write Cal (I assume Write Full is the same) that the dialog box goes to the upper left corner of my screen and I cannot move it back to the middle. Not critical but slightly annoying.

[Blacky]

Ok, 103A fixed the blank screen error but Ive found that clicking either the Read or Write Cal (I assume Write Full is the same) that the dialog box goes to the upper left corner of my screen and I cannot move it back to the middle. Not critical but slightly annoying.

My bad, I'll fix it. When I tested the release I was incorrectly testing build 102 (not 103) so I missed that.
I'm testing 103 now... (look out for 104 coming soon).

Regards
Paul

[ScarabEpic22]

My bad, I'll fix it. When I tested the release I was incorrectly testing build 102 (not 103) so I missed that.
I'm testing 103 now... (look out for 104 coming soon).

Regards
Paul

No problem, Ill keep my eyes peeled for 104 in the coming hours/days.

[ScarabEpic22]

RC3 fixed the blank screen and messed up flash/read window.