Error $0414

[NytLyt]

Hello,
I just purchased my Flashscan V2 and am trying to set up my SD card. It will not read or write, and when I try the F4-F2-F1 sequence suggested in another thread, I get an "$0414 SD card init loop 1 timeout" message. It is a Sandisk 4GB SDHC card that works and in a PC and was also formatted on the PC. Is there any work around to get this card to work, or do I have to use a lower capacity card?
Thanks

[Tordne]

FlashScan V2 supports upto 2GB cards only so it could simply be the capacity. Do you have a smaller one (from a camera perhaps) you can try? Obviously copy any data off you want before formatting :)

[NytLyt]

The smaller card worked. That's what I get for being capacity greedy when the 4GB was only $5 more than the 2GB. Thanks for your help.

[Tordne]

2GB is the maximum and is imposed by the FAT16 filesystem.