EXT.AD1 but no WO2AFR1

[tinindian]

Just getting started with my tune. Hooked up LC-1 with display and it reads fine (output 1 is connected to FlashScan V1). Scantool shows proper voltage fluctuations for EXT.AD1 when monitoring, shouldn't WO2AFR1 be changing too? Thanks.

[mr.prick]

You want {CALC.AFR_LC11} for AD1 & LC-1
EXT.WO2AFR1 is for serial WBO2 connection.

{CALC.AFR_LC11} is for the factory programed output of the LC-1's analog#2 (brown wire)
Read this post for more information on analog output settings. (http://forum.efilive.com/showthread.php?t=13229)

[joecar]

+1...

EXT.WO2AFR1/2 are for serial wideband connection (FlashScan V2 only).

EXT.AD1/2 are for analog wideband connection (V1 and V2).

[tinindian]

My bad. Thanks guys. Must read before posting....