recordes only up to 3000 frames now?

[JOHNGEAR]

question, why or what did I do that only allows 3000 frames?

[joecar]

In scantool, go Edit->Properties->Logging and set Frames (x1000) to a larger value like 100.

[JOHNGEAR]

thank you, so looking at my log...can you see why it seems to not have any power at a WOT launch? untill it can has climbed up to a higher RPM.

[joecar]

I only had a chance for a quick look at your files...

No power initially during WOT launch:
- there seems to be a flat spot in the TP waveform... I can't tell if you held the throttle steady at 34.9%, or what...?
- then, after that, throttle goes to 100% but no enrichment shows up at all;
refer to the first pic;

Look at B3618 and B3647: what happens if you go WOT at low RPM...? (AFR is going to be too lean)...

Do this:
- make the high MAP column of B3647 sufficiently rich for boost for all RPM's (richer than 12.6 is my understanding),
- make B3618 sufficiently rich all the way across.

Also note this:
- running out of injectors (183% DC),
- insufficient AFR for boost;
see second pic.

:)