mtnman
November 18th, 2005, 02:23 AM
I'm following the AutoVE tuning Tutorial by Andy Reyna (sp?) and when I monitor the map values and raise my speed to around 70mph, I get the reduced Engine power light. I've heard mention on this post to raise the values by more than the recommended 15%. Are these the values of the Main VE table?
Has anybody else gone through the tutorial with a 2500HD truck?
When I do go for a test drive and log data (keeping the speed below 70mph), I paste the values with count 50+ into the Main VE table, then I monintor the LTFT values and the values seem to be greater values than the -4 to +4 range. Am I missing something here?
If properly tuned, shouldnt the LTFT values ALWAYS be in the -4 to +4 range? I'm getting +6 and +8 values at times.
Has anybody else gone through the tutorial with a 2500HD truck?
When I do go for a test drive and log data (keeping the speed below 70mph), I paste the values with count 50+ into the Main VE table, then I monintor the LTFT values and the values seem to be greater values than the -4 to +4 range. Am I missing something here?
If properly tuned, shouldnt the LTFT values ALWAYS be in the -4 to +4 range? I'm getting +6 and +8 values at times.