KillaKustomKables
April 29th, 2010, 11:44 PM
Hey all,
I am involved in doing the electrics on duramax engine conversions. Problem I am having is when using the LMM engine and allsion transmissions is that there is no input/output on the ECM for tacho and cruise control, Its all done via CAN-bus
We have looked into running the LBZ operating system and modifiying the harness to suit, However the problem is that the allison trans behind the LBZ has a torque converter speed sensor, LBZ does not.
So what I would like to know is can we modify one of the operating systems to work. either change the LMM system to use analogue inputs for cruise/tacho rather than CAN, Or modify the LBZ system to run without the torque converter sensor.
At this stage we are looking at fitting the extra sensor into the later model gearboxes, but if we can sort it via software would be alot easier.
Also does anyone know if the LBZ and LMM air flow meters run the same calibration?
Thanks
Steve
I am involved in doing the electrics on duramax engine conversions. Problem I am having is when using the LMM engine and allsion transmissions is that there is no input/output on the ECM for tacho and cruise control, Its all done via CAN-bus
We have looked into running the LBZ operating system and modifiying the harness to suit, However the problem is that the allison trans behind the LBZ has a torque converter speed sensor, LBZ does not.
So what I would like to know is can we modify one of the operating systems to work. either change the LMM system to use analogue inputs for cruise/tacho rather than CAN, Or modify the LBZ system to run without the torque converter sensor.
At this stage we are looking at fitting the extra sensor into the later model gearboxes, but if we can sort it via software would be alot easier.
Also does anyone know if the LBZ and LMM air flow meters run the same calibration?
Thanks
Steve