fezz57
May 10th, 2010, 09:33 AM
while fooling around one day with the scan tool one day
i recalibrated the A/D inputs not knowing actually how to do it.
after some research i done the following.
1. open the Flashscan V2 control panel, uncheck the inputs i dont use (2,3,4)
2. press start
3. connect 1 x 1.5 V batterry to A/D 1
4. enter the exact mV (1516 mV)
5. press initialize
6. connnect 2 x 1.5 V betteries to A/D 1
7. enter the exact mV (3030 mV)
8. press calibrate
after this, i would expect the values in the tables to automatically appear.
or am i wrong.
the results i get, are as if there were no input voltage at all,
when i look at data, i see the vaoltage inputs registering but not when i try to calibrate.
anyone else have these issues,
i recalibrated the A/D inputs not knowing actually how to do it.
after some research i done the following.
1. open the Flashscan V2 control panel, uncheck the inputs i dont use (2,3,4)
2. press start
3. connect 1 x 1.5 V batterry to A/D 1
4. enter the exact mV (1516 mV)
5. press initialize
6. connnect 2 x 1.5 V betteries to A/D 1
7. enter the exact mV (3030 mV)
8. press calibrate
after this, i would expect the values in the tables to automatically appear.
or am i wrong.
the results i get, are as if there were no input voltage at all,
when i look at data, i see the vaoltage inputs registering but not when i try to calibrate.
anyone else have these issues,