PDA

View Full Version : Emissions not readys


64camino
May 27th, 2010, 02:29 PM
I have my truck and my buddies car, both trying to pass emissions, both with not readies.
My truck shows O2 not ready, heaterO2 not ready(current1)



His tune, O2, Heated O2, evap, and secondary AIR(dansmaggy)

any ideas?
Chevy366
May 27th, 2010, 05:31 PM
Hey just noticed the "similar threads" area at the bottom of this thread . Think God , similar threads on the same subject , easy access . ;-)
joecar
May 28th, 2010, 02:08 AM
Assuming you and your friend's vehicles still have all those devices intact, you have to perform a few drive cycles...
joecar
May 28th, 2010, 02:09 AM
Hey just noticed the "similar threads" area at the bottom of this thread . Think God , similar threads on the same subject , easy access . ;-)Hey that is handy...:cheers:
64camino
May 28th, 2010, 03:06 AM
No, both cars have no rear O2's. I have about 4,000 miles on mine since the last time it was flashed, I think that to be an adequate drive cycle ;) there's been about 250 miles on his.
Chevy366
May 28th, 2010, 04:33 AM
No, both cars have no rear O2's. I have about 4,000 miles on mine since the last time it was flashed, I think that to be an adequate drive cycle ;) there's been about 250 miles on his.
Hmmm, what if those were set to "not reported" ? Seems if they weren't reported they would pass .
The evap canistor thing is a pain , but if the other ones were "not reported" , but drive cycles are, if working properly, the ticket.
"not reported" and the SRT test just checks them off as ready.
64camino
May 28th, 2010, 05:04 AM
That's my problem, they are set to not reported, but still always show not ready. What would keep them from setting? btw I am running cos3 in both vehicles.
joecar
May 28th, 2010, 06:07 AM
Must also have MIL set to On (in addition to Not Reported).


Disclaimer: For offroad use in Mexico only.
Chevy366
May 28th, 2010, 06:59 AM
For off road use only .
Found this googling around : "P0131-P0167 - Oxygen sensors P0400-P0430 - EGR, AIR, and catalysts P1133-P1156 - Oxygen sensors P1404-P1416 - EGR and AIR systems P1441-P1443 - Evaporative purge Set to "not reported" should show you what you want to see, at least with regards to the tests. Leave the MIL indicator enabled for all " , not my work and have to state again "OFF ROAD USE ONLY" .
64camino
May 28th, 2010, 07:25 AM
Thank you all for your responses, will mess with it tonight and see where that gets me