pauly24
June 26th, 2010, 03:50 PM
Just need some help on connecting my 3A2 wideband to my flashscan for AFR logging.
http://wbo2.com/3a1/default.htm thats the info for the controller.
Ive changed this post, I think i've figured it out.
If you look at the RJ45 outputs on the techedge website, I think this just needs to hook straight up to the RJ11 on the flashscan.
RJ45 on techedge outputs are
1. SVout
2. RS232 RX
3. RS232 TX
4. WBlin
5. Ground
6. NBsim
7.
8. 12V
So should I make a new RJ45 cable with a RJ11 plug on the other end and only connect pins 2,3,5 and then connect this to the flashscan. What are the pins on the flash scan?
http://wbo2.com/3a1/default.htm thats the info for the controller.
Ive changed this post, I think i've figured it out.
If you look at the RJ45 outputs on the techedge website, I think this just needs to hook straight up to the RJ11 on the flashscan.
RJ45 on techedge outputs are
1. SVout
2. RS232 RX
3. RS232 TX
4. WBlin
5. Ground
6. NBsim
7.
8. 12V
So should I make a new RJ45 cable with a RJ11 plug on the other end and only connect pins 2,3,5 and then connect this to the flashscan. What are the pins on the flash scan?