one question after COS3

[wesam]

After upgrading to COS3 now how could i tune the VE table and the A0014 ?
as i understand i should tune the VE at one of the temperature in the A0014 then give it a factor of 1 then start to manipulate for the other temperature factors 40,50,60,...
but i could not tune the VE now because we are in the middle of summer and the temperature will not go below 33*C in the in the night so is it a good idea to tune it in the morning @ 40*C and make it the 1 in the A0014 ?

[joecar]

Yes tuning A0014 is a bit difficult...

You could tune your VE at any fixed IAT, and then log in the morning to get a correction.

As the weather cools down, you can extend the correction further down.

[wesam]

no i don't but i could make a filter to exclude all frames with temperature lower and higher than let us say 30C or 40C but i don't think its a good idea to tune a car at 40*C
so is there any other way to do it ?
why not the A0014 is not constant for all cars ?
and why we could not tune the VE table in any temp then if some one could give us a constant data for the A0014 some one could make a spread sheet which will give us the VE data which should enter to the tune file after converting it according to the constant factor of A0014

[joecar]

See this: showthread.php?2270-Show-me-your-A0014-s (http://forum.efilive.com/showthread.php?2270-Show-me-your-A0014-s)

[izaks]

What COS3 are you using ?
A0014 does not work in 01290003

[wesam]

I'm using 01250003

[izaks]

Is this for the car in your signature ?
If so, then 01250003 does not seem to be match for your car.
Cable or DBW ?

[wesam]

Cable

[izaks]

Cable
.
The only cable 04 GTO OS I can find is 12587604, which means you should have used COS3 0411003

[wesam]

I had the 01250001 for 2 years by a reputable tuner and just upgrade to 01250003 and don't have any problem