View Full Version : Is there a How to on MAF tuning?
wadesns
July 15th, 2010, 04:08 PM
Is there a write up or a tutorial on how to tune your MAF after dialing in onrs VE table? If not anyone mind pointing me in the correct direction?
Thanks
..RJ..
joecar
July 15th, 2010, 06:30 PM
Do this:
Follow the AutoVE Tutorial with these exceptions:
- enable MAF (undo the MAF fail steps),
- set B0120 to zero,
- setup BEN map to look exactly like B5001 (using copy-with-label and paste-labels),
- log MAF and MAFFREQ.
It works the same way... obtain a log, apply transient filter, paste/multiply BEN map into B5001.
joecar
July 15th, 2010, 06:32 PM
I sometimes log DYNAIR while in OLSD after having finished AutoVE, and I use its values as an initial MAF table.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.