TaTommy888
December 4th, 2005, 01:01 AM
I'm getting ready to do a SD tune with EFI's custom OS.
I have a 2003 Z06 with STS's twin turbo system. My MAF also containt the AIT sensor, so I cannot physically disconnect it.
I read through the directions, and set my MAF parameters accordingly, but when I run the car on this new tune, it runs exactly the same, and when I run a scan, the MAF data is still present.
I remember reading somewhere that on some cars, you HAVE to disconnect the MAF physically. How do I do this with the IAT sensor install. Can I just disconect certain wires?
Thanks for any info!
Tommy :)
I have a 2003 Z06 with STS's twin turbo system. My MAF also containt the AIT sensor, so I cannot physically disconnect it.
I read through the directions, and set my MAF parameters accordingly, but when I run the car on this new tune, it runs exactly the same, and when I run a scan, the MAF data is still present.
I remember reading somewhere that on some cars, you HAVE to disconnect the MAF physically. How do I do this with the IAT sensor install. Can I just disconect certain wires?
Thanks for any info!
Tommy :)