View Full Version : Why is this PID invalid?
mr.prick
September 6th, 2010, 11:12 AM
{EXT.WO2EQR1}
It does not work with passthru but will work with BBL. :nixweiss:
All the other Serial WO2 PIDs work except the EQ ones.
An important PID for me, especially w/RTACS. :sneaky:
Build & FW in sig.
WeathermanShawn
September 6th, 2010, 12:39 PM
Mr. Prick:
I am running the same FW and Build numbers as you. I am using the RR PCM and did this log today utilizing pass-through (non-BBL).
Look it over, but I seem to be logging WO2EQR1 O.K.
..Shawn..
mr.prick
September 6th, 2010, 01:38 PM
It's working on my other laptop. :confused:
I copied the sae.generic.txt between the two to no avail.
Maybe a registry thing.:nixweiss:
swingtan
September 6th, 2010, 02:07 PM
Maybe PEBCAK ?........
WeathermanShawn
September 6th, 2010, 02:19 PM
It's working on my other laptop. :confused:
I copied the sae.generic.txt between the two to no avail.
Maybe a registry thing.:nixweiss:
I run mine on two laptops also. The one with Windows 7 has thrown a few hiccups at times..though I can't say I have had that particular issue. I end up running it on the Windows XP one most of the time..:confused:.
Like you said, perhaps a registry issue?:confused:
mr.prick
September 6th, 2010, 02:53 PM
I just went out and validated all PIDs and now it works. :doh:
Didn't think to do this because it's an external/cal_pid.
Weird how it was just the one.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.