PDA

View Full Version : How to install Wideband o2 sensors



ippielb
October 22nd, 2010, 10:38 AM
Hello, i just got my wideband o2 sensors in the mail today. note this is just the o2 sensors. I have two NTK 24320 5 wire 6 pin sensors. My truck has 4 o2 sensors on it, two infront of the cats, and two behind the cats. IF i had cats that is. The stock sensors are 4 wire 4 pin sensors. All i have is the sensors, nothing else.

Where should i start?

swingtan
October 22nd, 2010, 11:19 AM
Did you get a WB controller to go with the WB Sensors?

You cannot just plug in the WB sensors, you will need a control unit to both control the heater in the WB sensors and convert the signal to a usable level for logging.

Simon.

ippielb
October 22nd, 2010, 11:50 AM
I did not get a controller with the sensors, thats what i was after, i just didn't know what you call it, i didn't want to make a fool of myself. What is a controller you would recommend. I need one that is sealed, waterproof and dust & mud proof, heavy duty. Unless i can relocate them into the cab.

Thanks

ippielb
October 28th, 2010, 11:21 AM
What controller should i get, i have only been able to find one, is there a brand anyone recommends?

mr.prick
October 28th, 2010, 10:55 PM
What O2 sensors did you get?
Hopefully they can be used with the WBO2 controllers that are available.

ippielb
October 29th, 2010, 05:14 AM
I have NTK 24320 5 wire 6 pin sensors

BowlingSS
December 9th, 2010, 06:54 AM
I have used the LC-1 controller for years. Sealed unit.
http://www.innovatemotorsports.com/products/lc1.php

Good luck.
Bill